5 (419) · $ 17.50 · In stock
When I print with PLA, I get a perfect first layer. However, when I print with PETG, the first layer looks like this: I've read all the info that suggests reducing the temp, speed, and increasing
Problems with first layer PET any suggestions? PLA benchy printed fine. : r/prusa3d
Problems with PETG first layer – Assembly and first prints troubleshooting – Prusa3D Forum
Ender Petg Z Offset Best Prices
Extra extrusion at seam of print with PETG - 3D Printing Stack Exchange
Rough layers : r/ender3
underextrusion - Missing filament at Z seam - 3D Printing Stack Exchange
prusa i3 - Issue with PETG adhesion - 3D Printing Stack Exchange
Why does my top layer look so bad? The rest of the print is perfect : r/ 3Dprinting
petg - What are these defects caused by? - 3D Printing Stack Exchange
Extra extrusion at seam of print with PETG - 3D Printing Stack Exchange